artek писал(а):
Canopus3 в принципе имеет плагин для последних Prem. только не помню или под CS3/4. А экспорт в TGA, или какой другой не QT формат (напр. AVI) получаеться? может сам Premiere глючит
сделал экспорт в несжатый .mov YUV 8-bit 4:2:2 - потом перекодировал в photo Jipeg с помощью Quicktime Pro - в итоге получил 3 отлупа за три файла:
Цитата:
The file you have submitted has black pixels on the edges of the frame. This may have been caused by the camera, or it may have been the editing system sequence preferences but in any case, the problem will need to be resolved before we can continue with inspection. One thing to check is ensure that the file is dead center on the XY axis in your editing sequence. Also it is important that when viewing files you ensure that your reference monitor is set to underscan so that the entire edge of the frame is revealed.
One way to fix it is to enlarge image. You should be able to expand the picture to the edge of the frame without losing too much quality.
If you find that your camera is responsible for this, you should have it looked at by a service department to see if it can be fixed.
Цитата:
This file appears to have been submitted with incorrect settings and is therefore not displaying properly in previews. This is likely a result of incorrect pixel aspect ratio settings.
до этого, на старой винде и Adobe Premiere pro 2 с помощью Canopus все экспортировалось и принималось нормально, настройки в самой камере не менял...